Page 1
SPEAKER STAND TD508 speaker only SPEAKER STAND TD510 speaker only OWNER’S MANUAL Thank you for purchasing this high quality speaker stand. Please read this installation manual before assembling the stand, and be sure to use it properly. An accident or injury can result if the stand is incorrectly assembled or unspecified parts are used.
Page 2
Included P Included P Check that all of the following components are present Check that all of the following components are present components Hexagonal bolt Joint Post Base plate Allen key Spike hole seal Pan-head bolt Foot D6 components Base plate Joint Post Screw (binding)
Page 3
Using this product saf ely and proper Using this product saf ely and proper The indicator symbols shown below are used in this manual and on the stand to ensure proper and safe use of the product, prevent injuries and avoid damage to surrounding items. Please become familiar with these symbols and their associated information before proceeding to the assembly instructions of this manual.
Installation Installation - Removing the speakers - Remove the screws from the bottom of the speaker base bracket. Screws Base bracket Speaker Remove the base cover. Speaker Base cover Remove the angle adjustment screw and the washer. Speaker Washer Angle adjustment screw Slide the speaker to the right and then lift it up to remove it.
Page 5
- Assembling the speaker stand (for D3 Install the base plate and the post with the pan-head bolt. Hexagonal bolt Joint Insert the Hexagonal bolt (speaker turn-prevention Hexagonal bolt bolts) into the joint. (speaker turn- prevention bolts) Post Assemble the joint and the post with the Hexagonal bolt.
Page 6
- Assembling the speaker stand (for D6) - Install the base plate and the post with the pan-head bolt. Screw (binding) Joint Assemble the joint and the post with the Screw (binding). Post Base plate Pan-head bolt Place the insulator under the base plate, and then Speaker Speaker Stand install the spikes and nuts to the base plate.
- Routing speaker wire - When connecting the speaker wire, connect it securely so that the end of the speaker wire does not touch any neighboring terminals. Speaker Wire Speaker Wire - Speaker angle adjustment - Loosen the angle adjustment screw on the right side of the speaker.