Eclipse CB1 Installation Manual page 10

21
Securely install the speaker to the bracket by using the
stubby screwdriver to tighten the screws.
Caution
• • The speaker can be adjusted to within 10° on each
side by loosening the screws.
• • When adjusting the direction of the speaker, only
loosen the screws. They should never be removed. If
all of the screws are removed, the speaker may fall
down.
22
Install the drop-prevention wire to the ceiling.
Caution
Install the drop-prevention wire securely to the ceiling so
that the speaker will not fall down.
Tip
Install the drop-prevention wire to the ceiling in a place
it can reach which is strong, such as a beam location.
2 Bracket
4 Screw X4
Wire
3
Screws
(sold separately)
– 10 –
Stubby screwdriver
Speaker
Speaker