Table of Contents
Advertisement
Troubleshooting Guide
Heating System
Symptom
Does not heat
Too hot
Flashing temperature of 34°F or
134°F appears on the display
Electrical System
Symptom
Will not turn on – in any mode
Turns on by itself
Light is out
Pump shuts down unexpectedly
while in use
3 flashing LEDs appear on the Top
Side Control
Aquatic Fitness System
Troubleshooting Guide
Problem
1.
Temperature setting is too low
2.
Dirty filter
3.
Flow switch out of adjustment
1.
Temperature setting is to high
2.
High limit tripped
Possible temperature sensor failure
Problem
No power
Normal automatic daily power filtration, or
anti-freeze cycle
Burned out bulb
1.
Automatic 30-minute timer has shut
pump off
2.
Motor over-heated and automatic
protective device has shut down
pump(s)
Possible sensor errors
Corrective Action
1.
Turn up the thermostat
2.
Clean filter
3.
Call for service
1.
Turn down the thermostat
2.
Call for service
Call for service
Corrective Action
Check circuit breaker and/or GFCI
No action required
Replace bulb
1.
Push JETS pad again to start another
30-minute cycle
2.
If pump(s) will not restart when JETS
pad is pushed, call for service
Make sure that the equipment panel
vent area is not blocked. Vent
blockage can cause serious damage to
your equipment.
1.
Check water level
2.
Clean filter
If problem persists:
1.
Turn off power
2.
Restart the system
If problem persists:
Call for service
27
Advertisement
Table of Contents
