Stain Removal - Bissell 7901 - AUTRE User Manual

Carpet Cleaning Continued
Repeat cleaning passes until solution being pulled up
4.
appears clean.
Continue passes without pressing the trigger until you
5.
can't see any more water being pulled up.
Note: Both the SmartMix Bottle and the clean
After cleaning, you may want to turn the SmartMix Dial
6.
to the Water Rinse setting to give your carpeting a final
rinse. This will ensure thorough removal of embedded
dirt loosened by the BISSELL Advanced Deep Cleaning
Formula. BISSELL Advanced Deep Cleaning Formulas
contain an anti-resoiling agent that helps your carpets
repel dirt and keeps them looking good longer.
When the cleaning job is complete refer to the
7.
Maintenance section on pages 15-16 for machine
cleanup and storage instructions.
Note: You may notice hair and debris deposits

Stain Removal

Do Not Delay! Failure to attend to an accident soon after it occurs
may cause it to set and become permanent.
Before treating any stain, follow these pretreatment steps:
Blot up liquids with an absorbent cloth or paper towels.
1.
White materials are recommended because certain dyes
may bleed and make the stain worse.
Gently scrape up semi-solids with a spoon or spatula.
2.
Do not use a knife or other utensil with sharp edges
because it could damage the carpet or upholstery.
If the area has dried, remove the remaining semi-solids
3.
and residue with a sweeper or vacuum.
Be sure to pre-test any spot removal solutions or chemicals
4.
on an inconspicuous area first. This is extremely
important; different dyes and materials could be damaged
or discoloured by a cleaning solution. If such a change
should occur, try a different solution or call a professional. If
cleaning on Berber Carpet gently run your machine over
a hidden area. If no fuzzing occurs, continue cleaning in
soiled area.
12
water Tank must have liquid in them in
order for the machine to spray. If one is
empty, the machine will temporarily lose
prime and will not spray cleaning solution
or water.
on the carpet that were loosened by the
brushing action (especially with newer
carpets that have never been deep cleaned
before). This debris should be picked up
and thrown away. Debris that deposits in
the Brush Belt should be cleaned between
uses to keep the Belts running free.