Bissell 7901 - AUTRE User Manual page 16

Routine Maintenance Continued
Remove and rinse tools in clean, running water. Dry and
3.
replace on Tool Caddy.
Coil Flex Hose around storage brackets on Tool Caddy.
4.
Remove Tank-In-Tank, dispose of dirty water. Refer to the
5.
Features section on Pages 8-9.
Rinse out Tank-In-Tank and replace on the machine; Clean out
6.
Lint Screen.
Clean out the Flow Indicator Filter each time it is used to ensure
7.
best cleaning performance. Unscrew the Flow Indicator Cap, lift
out the Red Rotor and White Filter. Rinse all three parts in tap
water. Replace the Filter and Rotor. Replace the Flow Indicator
Cap; turn until snug, do not over-tighten.
Wipe all exterior surface with a soft cloth.
8.
Store cleaner upright in a protected, dry area.
9.
Note: ProHeat II uses water and must not be stored
where there is a danger of freezing. Freezing will
damage internal components and void the warranty.
When carpet is dry, vacuum again to remove hair and fuzz
10.
that the ProHeat II may have loosened.
Pump Belt Replacement
Turn the Power Switch OFF and unplug from the outlet.
1.
Step on the Handle Release and recline the handle down onto
2.
floor (see illustration).
Remove Tank-In-Tank and SmartMix Bottle. Set them aside
3.
(see illustration).
Remove Belt Access Door located near the Floor Cleaning/Tools
4.
switch by inserting a flat head screwdriver into the slot nearest to
the handle and gently prying the access door off (see illustra-
tion).
Turn the machine onto its side so the belt access area is
5.
facing upward (see illustration).
On the bottom of the machine, near the belt access area,
6.
is a red retainer plate that holds the black brush arm and
brush in place. Using a Phillips head screwdriver remove the
screw that holds the red retainer plate in place. Set red
retainer plate and Phillips head screw aside (see illustration).
16
Cap
Rotor
Filter
2
3b
3a
5
4
6