How To Use This Guide; How To Put It Together - Bissell 7901 - AUTRE User Manual

How To Use This Guide

This User's Guide has been designed to help you get the utmost
satisfaction from your BISSELL ProHeat II. You'll find assembly and
operating instructions, safety precautions, as well as maintenance
and troubleshooting instructions. Please read this User's Guide
thoroughly before assembling your deep cleaner.
Pay particular attention to the product diagram, assembly
instructions, and part names. Locate and organize all parts before
assembly. Familiarize yourself with the parts and where they go.
Following this User's Guide will greatly enhance your ability to
get the most performance from your BISSELL ProHeat II for many
years.
Your ProHeat II comes in 3,
easy to assemble components.
Upper Handle
Lower Handle
Tool Caddy
The only tool you will need to assemble your cleaner is a Phillips
head screwdriver.

How To Put It Together

Refer to Assembly Diagram on page 4
Slide Upper Handle firmly onto Lower Handle until screw
1.
holes are completely aligned.
Feed bundled Power Cord through Tool Caddy from Caddy's
2.
flat side.
Align Upper Handle holes and Tool Caddy holes.
3.
Place hex nut into back of Tool Caddy and hold in place. Insert
4.
bolt from front to back turning into the hex nut until snug. Do
not over tighten. Repeat for the second bolt and hex nut.
Insert 2 screws into lower 2 holes.
5.
Turn until snug.
Snap tools into storage on the Tool Caddy as shown in
6.
figure 6.
Wrap Power Cord and Flex Hose as shown in figure 7.
7.
Insert TurboBrush into storage on Upper Handle by tilting
8.
the top of the TurboBrush and snapping it into place.
ProHeat II assembly is now complete.
WARNING:
Do not plug in your cleaner
until you have completely
assembled it per the following
instructions and are famil-
iar with all instructions and
operating procedures.
2
4
5
6
7
5