Dometic 300 Series Installation Instructions Manual
Sanitation toilets
Hide thumbs
Also See for 300 Series:
- User manual ,
- Instruction manual (55 pages) ,
- Installation and operation manual (54 pages)
Related Manuals for Dometic 300 Series
Summary of Contents for Dometic 300 Series
- Page 1 DOMETIC SANITATION TOILETS 300 Series, 10 Serie 320 Series Toilets Gravity-flush toilet Instruction manual [Dzochccs €d' 90/7-07- S 8/chMn T; 32 cÖu)lD,...
- Page 2 Each Dometic toilet is 100% factory-tested to assure a watertight seal in the toilet bowl before it is shipped. After installation at the RV or other vehicle factory, the entire toilet and waste tank system is flood- tested for leaks by filling the system with water to the rim of the toilet bowl.
- Page 3 Toilet bowl must be regularly cleaned and winterized according to "Cleaning" and "Winteriza- tion and storage" procedures in this manual, or your warranty coverage may be voided. Intended Dometic 300, 310 and 320 series toilets provide lightweight, residential-size toilets for installation directly above a holding tank. Benefits PowerFIush technology.
- Page 4 Toilet model identification The toilet model identification label is located on the toilet base under the water valve. Please have this information ready if contacting Dometic for customer service. Contact information SO 1234 123456789 There is a strong, worldwide network to assist in servicing and...
- Page 5 Routine toilet cleaning For routine cleaning, use SeaLand@Toilet Bowl Cleaner. If this cleaner cannot be found in your area, contact Dometic for your nearest dealer. If the cleaner is not available, use most any non-abrasive bathroom and toilet bowl cleaner.
- Page 6 Specifications Materials Toilet bowl: vitreous ceramic (models 310, 311, Foot pedal: polypropylene 320, 321); polypropylene (models 300, 301) Water valve: polypropylene Toilet seat: polypropylene (models 300, 301, 310, Vacuum breaker: ABS/poIypropylene 311); enameled wood (models 320, 321) Floor seal: nitrile rubber, foam Flush ball seal: nitrile butyl rubber Toilet base: polypropylene...
- Page 7 Floor seal: nitrile rubber, foam Flush ball seal: nitrile butyl rubber Toilet base: polypropylene Minimum installation requirements Fitting 0.5 in. NPT Water 3.0-5.0* gpm / 11.4-18.9 lpm recommended Flow rate Supply 2.0 gpm / 9.5 lpm minimum Static pressure 30-100 PSI / 206.8-689.5 Discharge Floor flange...
- Page 8 Toilet bowl Floor mounting hardware kit Toilet base Refer to complete parts list (availableonline at Flush pedal www.dometic.com) for additional information. Floor flange seal Installation Note Besure footpedal, when pressed, touches same flatsurface o nwhich t oilet i sinstalled. Note Besureto followrecommended installation requirements inthismanual.
- Page 9 When a Dometic toilet is stored for long periods of time or may be exposed to temperatures below freezing, the toilet must be winterized or stored according to one of the following procedures. Caution This toilet is not intended for use when exposed to temperatures below freezing.
- Page 10 Water valve is worn or damaged. d. Plugged rim wash holes or rim d. Clean rim wash holes. jet (300 series only) in toilet. Hand sprayer is defective. Replace hand sprayer. 7. Hand sprayer leaks (hand sprayer is not provided with all models).
- Page 11 90 days from the date of purchase. ID. This warranty covers all parts Of the Dometic toilet which is warranted to be free of defects in material and workmanship under normal use.
- Page 12 Dometic Group supplies a wide range of workshop equipment for service and maintenance of built-in air conditioners. Dometic Group also provides...
Need help?
Do you have a question about the 300 Series and is the answer not in the manual?
Questions and answers