Linksys SRW224P - 10/100 - Gigabit Switch User Manual page 20

Wireless-G Access Point with Power Over Ethernet and Rangebooster
• Advanced Wireless Settings. Use this screen to configure the Access Point's more advanced wireless
settings.
• VLAN & QoS. Use this screen to configure VLAN and QoS settings.
AP Mode
Use this screen to configure the Access Point mode. The three available modes are Access Point, Wireless
Repeater, and Wireless Bridge.
Security Monitor
• Basic Settings. Use this screen to configure the Access Point's security monitor capabilities. You will be able
to monitor your wireless network through a client utility on administrator's PC.
• Event Log. Use this screen to determine the events that should prompt notification and the notification
recipient settings.
Administration
You will use the Administration tabs to manage the Access Point.
• Management. This screen allows you to customize the password and Simple Network Management Protocol
(SNMP) settings.
• Log. Configure the Log settings for the Access Point on this screen.
• Factory Default. Use this screen to reset the Access Point to its factory default settings.
• Firmware Upgrade. Upgrade the Access Point's firmware on this screen.
• Reboot. Use this screen to reboot the Access Point.
• Config Management. You can save the configuration file for the Access Point to your PC, as well as restore the
backup configuration file to the Access Point.
Chapter 5: Setting Up the Wireless-G Access Point
Navigating the Utility
snmp: the standard network management protocol
on the Internet.
firmware: the software image that runs on a
CPU inside a networking device.
14