Chapter 4: Connecting The Wireless-G Access Point; Overview; Connection; Figure 4-1: Connect The Ethernet Cable - Linksys SRW224P - 10/100 - Gigabit Switch User Manual

Wireless-G Access Point with Power Over Ethernet and Rangebooster

Chapter 4: Connecting the Wireless-G Access Point

Overview

This chapter explains how to place and connect the Access Point.
Depending on your application, you might want to set up the device first before mounting the device. Refer to
"Chapter 5: Setting Up the Wireless-G Access Point".

Connection

1. Connect your Ethernet network cable to your network router or switch. Then connect the other end of the
network cable to the Access Point's Ethernet port.
2. If you are using Power Over Ethernet (POE), proceed to the following section, "Placement Options."
If you are not using POE, then connect the included power adapter to the Access Point's Power port. Then plug
the power adapter into an electrical outlet. The LEDs on the front panel will light up as soon as the Access
Point powers on.
Proceed to the following section, "Placement Options."
Chapter 4: Connecting the Wireless-G Access Point
Overview
hardware: the physical aspect of
computers, telecommunications, and
other information technology devices.

Figure 4-1: Connect the Ethernet Cable

Figure 4-2: Connect the Power

10