RocketFish RF-CRDRD Quick Setup Manual

RF-CRDRD I All-in-One Internal Card Reader I Quick Setup Guide

Package contents

• Card reader with USB 5-pin cable
• Mounting screws (ISO 3f 4mm) (4)
• Extra front bezel (1)
• Utility CD (includes AP drivers and User Guide)
• Quick Setup Guide

Minimum system requirements

• IBM-compatible PC
• CD drive
• One available on-board 5-pin USB connector on the
computer's system board
• One available 3.5-inch drive bay
• Windows® 2000, Windows® XP, Windows® Vista, or Windows® 7
Installing the card reader
Caution: Electrostatic discharge (static electricity) can damage
electronic components. Make sure that you are grounded before
you install your card reader. Turn off your computer, then touch a
bare metal part of your computer, such as the back of the chassis
or power supply, to discharge any static electricity.
To install your card reader:
1 Turn off your computer and disconnect the power cord.
2 Make sure that you are correctly grounded by touching a bare
metal part of your computer, such as the back of the chassis or
power supply.
3 Open your computer's cover. For more information, see the
documentation that came with your computer.
4 If you want the alternate colored bezel,
change it now by pressing the plastic
clips on each side of the card
reader with a pen or pencil
and pulling the bezel off . Plastic
clip
5 Snap the new bezel into place.
6 Make sure that your computer's system board corrector is
compatible with your card reader's USB connector.
Function
Pin Wire color
P5 No Contact No Contact
P4 Black/shield Ground
P3 Green D+
P2 White D-
P1 Red Vbus
7 Carefully slide your card reader into the empty 3.5" drive bay.
8 Secure your card reader to
the drive bay with the four
mounting screws (two
screws per side).
Screw
9 Connect your card
reader's USB connector to a
compatible USB connector
on your computer's system
board. (See illustration under step 6.)
10 Make sure that you have removed any tools or loose screws
from inside your computer, then replace your computer's cover.
11 Reconnect your computer's power cord, then turn on your
computer.
Using the card reader
To access a media card:
1 Insert a card into the appropriate slot, as shown in the table.
Caution: Cards must be inserted into the correct slot and in
the correct direction. Failure to do so may result in damage
to your card and/or card reader.
2 Open the My Computer or Windows Explorer applications,
then double-click the drive icon for the slot you are using.
3 To access fi les and folders on the inserted card, use normal
Windows procedures for opening, copying, pasting, or
deleting fi les and folders.
4 When you have fi nished working with the fi les on a memory
card, right-click the memory card icon in My Computer or
Windows Explorer and select Eject. The LED on the memory
card reader will turn off after the card is removed.
Caution: Do not remove memory cards while the data LED
on the reader is fl ashing.
Understanding the LED indicator
Screw
The activity LED indicates when a slot is reading from or writing to
a card.
• LED off —Your card reader is not being used.
• LED on—A card is inserted in one of the slots.
• LED fl ashing—Data is being transferred to or from a card.