NETGEAR FS108P - ProSafe Switch Application Notes page 13

4.2.5. Enable prioritization on the FS726TP
The Avaya IP Telephones tag audio and signaling packets with an 802.1P value of 6 by default.
This value was also administered on the Avaya Communications Manager (Figure 3) so that
traffic from the Avaya Communications Manager has the same value.
This priority method is not VLAN specific on the FS726TP.
Open the NETGEAR web interface and select QoS from the left window. Then select IEEE
802.1P Based QoS from the pull-down menu. Select High from the QoS pull-down menu for
Priority 6.
Figure 10: NETGEAR FS726TP 802.1P QoS Configuration
JJA; Reviewed:
SPOC 5/17/2007
Solution & Interoperability Test Lab Application Notes
©2007 Avaya Inc. All Rights Reserved.
13 of 20
NETGEARAppNotes.doc