NETGEAR FS108P - ProSafe Switch Application Notes page 12

4.2.4. Define the Default VLAN for untagged packets
Select PVID Setting from the pull-down menu and assign the Data VLAN (100) to each of the
PoE Ports and the uplink port as the default VLAN for those ports. Select Apply.
Figure 9: NETGEAR FS726TP PVID (Default) VLAN Configuration
Using the Data VLAN as the Default VLAN for the Avaya IP Telephones is essential to the
correct operation of a PC attached to the telephone. In most situations, the PC will not be
providing IEEE802.1Q tags and the data traffic needs to be on a separate VLAN from the Voice
traffic for prioritization.
Select VLAN 1 (Default) from the pull-down menu and remove (Not Member) the ports using
the Voice VLAN (1-12 and 26).
The DHCP services on the Data VLAN need to be configured to move telephones that have not
been correctly configured to the Voice VLAN. The administration is covered in Section 5.1.1.
JJA; Reviewed:
SPOC 5/17/2007
Solution & Interoperability Test Lab Application Notes
©2007 Avaya Inc. All Rights Reserved.
12 of 20
NETGEARAppNotes.doc