4 SmartConsole Utility
Protocol version: Displays the software version of the Utility.
Product Name: Displays the device product name.
System Name: Displays the appointed device system name.
DHCP: Specify if the device gets the IP address from a DHCP server.
Location: Displays the location of the appointed device.
Trap IP: Displays the IP address of the host where the Trap information will be sent.
Subnet Mask: Displays the Subnet Mask setting of the device.
Gateway: Displays the Gateway setting of the device.
Device Group Interval: Displays the intervals (in seconds) that the Switch will be discovered in the
SmartConsole Device List
Firmware version: Displays the current Firmware version of this device.
LLDP: Displays the LLDP (Link Layer Discovery Protocol) status of the device.
SNMP: Displays the SNMP status of the device.
NOTE: If the devices are marked red in the device
list, it means that a firmware upgrade is required
again.
NOTE: The LLDP function is only provided by PoE
models. For non-PoE models, the LLDP column
will appear blank.
18
D-Link Web Smart Switch User Manual