Delta 22-470 Instruction Manual page 15

7. If an adjustment to the outfeed table roller is neces-
sary, loosen locknut (G) Fig. 26, which is located under
the table and below the outfeed table roller (F), and
rotate adjustment nuts (H) as necessary, to raise or
lower the height of the outfeed roller (F). NOTE: It will
be necessary to raise the table to gain access to the
adjustment nuts. Tighten locknut (G) Fig. 26, after the
adjustment is made.
8. Check and adjust the height of the outfeed table roller
on the other side of the table in the same manner.
ANTI-KICKBACK FINGERS
A series of anti-kickback fingers (A) Fig. 27, are provided
on the infeed end of the planer to prevent kickback of the
workpiece during planing operations. These anti-kickback
fingers operate by gravity and no adjustment is required. It
is necessary, however, to inspect them occasionally to
make sure they are free of gum and pitch and that they
operate independently and freely.
WHEN INSPECTING AND CLEANING THE
ANTI-KICKBACK FINGERS, MAKE CERTAIN
THE MACHINE IS DISCONNECTED FROM THE POWER
SOURCE.
CHECKING AND ADJUSTING DRIVE
BELT TENSION
Proper belt tension is when there is approximately
deflection, using light finger pressure on the drive belts (A)
Fig. 28, midway between pulleys. If an adjustment is nec-
essary, proceed as follows:
1. DISCONNECT THE MACHINE FROM
THE POWER SOURCE.
2. Disengage feed roller lever (B) Fig. 28.
1 / "
4
A
15
F
G
H
Fig. 26
A
Fig. 27
Fig. 28
B