Service Mode List; Confirmation Of Using Hours; Note For The Replacing Of Memory Ic - Memorex MT1125SM Service Manual

This unit provided with the following SERVICE MODES so you can repair, examine and adjust easily.
Set Key Remocon Key
0
VOL. (-) MIN
VOL. (-) MIN 1
VOL. (-) MIN 6
VOL. (-) MIN 8
VOL. (-) MIN 9
POWER ON total hours can be checked on the screen. Total hours are displayed in 16 system of notation.
1. Set the VOLUME to minimum.
2. Press both VOL. DOWN button on the set and the Channel
button (6) on the remote control for more than 2 seconds.
3. After the confirmation of using hours, turn off the power.
If a service repair is undertaken where it has been required to change the MEMORY IC, the following steps should be taken to
ensure correct data settings while making reference to TABLE 1.
NOTE: No need the setting for after INI 09.
1. Enter DATA SET mode by setting VOLUME to minimum.
2. Press both VOL. DOWN button on the set and the Channel button (6) on the remote control for more than 2 seconds.
3.
ADDRESS and DATA should appear as FIG 1.
4.
ADDRESS is now selected and should "blink". Using the SET + or - keys on the remote, step through the ADDRESS until
required ADDRESS to be changed is reached.
5.
Press ENTER to select DATA. When DATA is selected, it will "blink".
6. Again, step through the DATA using SET + or - until required DATA value has been selected.
7. Pressing ENTER will take you back to ADDRESS for further selection if necessary.
8. Repeat steps 4 to 7 until all data has been checked.
9.
When satisfied correct DATA has been entered, turn POWER off (return to STANDBY MODE) to finish DATA input.
The unit will now have the correct DATA for the new MEMORY IC.

SERVICE MODE LIST

Releasing of V-CHIP PASSWORD.
Initialization of the factory.
NOTE: Do not use this for the normal servicing.
POWER ON total hours is displayed on the screen.
Refer to the "CONFIRMATION OF USING HOURS".
Can be checked of the INITIAL DATA of MEMORY IC.
Refer to the "NOTE FOR THE REPLACING OF MEMORY IC".
Writing of EEPROM initial data.
NOTE: Do not use this for the normal servicing.
Display of the Adjustment MENU on the screen.
Refer to the "ELECTRICAL ADJUSTMENT" (On-Screen Display Adjustment).

CONFIRMATION OF USING HOURS

NOTE FOR THE REPLACING OF MEMORY IC

INI INI
ADDRESS
00 01
DATA 88 6C
Operations
ADDRESS
INIT 00
0010
CRT ON
FIG. 1
INI INI INI INI INI
02 03 04 05 06
80 00 00 00 00
Table 1
C-1
DATA
Initial setting content of MEMORY IC.
83
POWER ON total hours.
= (16 x 16 x 16 x thousands digit value)
+ (16 x 16 x hundreds digit value)
+ (16 x tens digit value)
+ (ones digit value)
INI INI INI
07 08 09
98 07 04