Restore Source Server To Its Original Configuration; Remove Nds/Edirectory From The Destination Server - Novell SERVER CONSOLIDATION MIGRATION TOOLKIT 1.1 - ADMINISTRATION GUIDE 12-23-2005 Administration Manual

If Begin NDS/eDir Migration (Step 3) successfully completed and the destination server has already
rebooted and taken on the name and identity of the source server, complete the steps in the following
sections:
1. "Remove NDS/eDirectory from the Destination Server" on page
2. "Remove NDS/eDirectory from the Source Server" on page
3. "Restore NDS/eDirectory to the Source Server" on page
4. "Reinstall the Destination Server" on page

12.11.1 Restore Source Server to Its Original Configuration

If Begin NDS/eDir Migration (Step 3) failed and the destination server did not reboot and take on
the name and identity of the source server, you need only restore NDS/eDirectory to the source
server. When NDS/eDirectory has been restored, you have restored the source server to its original
configuration and you are ready to try the NDS/eDirectory migration again.
1 Enter one of the following at the server console of the source server:
• load install if the source server is running NetWare 4
• nwconfig if the source server is running NetWare 5 or later
2 Select Directory Options > Directory Backup and Restore > Restore Local DS Information
after Hardware Upgrade.
3 Press F3 and enter sys:system\nuw30\ndsbu when prompted for the location of the
backup files.
NDS/eDirectory has now been restored to the source server.
IMPORTANT: Do not reboot the destination server. Because the destination server did not
take over the identity of the source server, no other action is required prior to performing the
NDS/eDirectory migration again.
4 Perform the NDS/eDirectory migration again.
4a Launch Migration Wizard and open the project you were previously working on.
4b When the project opens and you see the Project Window, click Begin NDS/eDir
Migration.
4c Follow the instructions in
Migration," on page

12.11.2 Remove NDS/eDirectory from the Destination Server

If Begin NDS/eDir Migration (Step 3) successfully completed and the destination server has already
rebooted and taken on the name and identity of the source server, you must remove NDS/eDirectory
from the destination server before you can restore NDS/eDirectory to the source server.
1 At the destination server console, enter nwconfig.
2 Select Directory Options > Remove Directory Services from This Server.
3 Press Enter when you see a warning instructing you to not remove Directory Services.
Ignore any other errors during the removal of NDS/eDirectory.
4 Select Yes to remove Directory Services.
114.
Section 11.6, "Migration Step 3: Begin NDS/eDirectory
101.
111.
112.
113.
Troubleshooting Server Migrations 111