12.11.5 Reinstall the Destination Server
To perform the migration again, you must reinstall the operating system on the destination server.
TIP: If you had your server imaged, you can just restore the image rather than reinstall the server.
1 Bring down the destination server.
2 Install NetWare and follow the on-screen instructions during the installation.
After NetWare is installed on the destination server, you are ready to perform the eDirectory
migration again. Go to
page
12.12 CCS_pbeDecrypt Error When Migrating
from NetWare 5.0
When performing a migration from NetWare 5.0, you might receive a CCS_pbeDecrypt error on the
source server console when attempting to back up either the source server trustees or the NDS
database.
If this occurs, make sure that the latest Support Pack is installed on the NetWare 5.0 server and then
do the following:
1 At the NetWare 5.0 source server console, enter
2 At the DOS prompt, enter.
3 Enter.
4 Restart the NetWare 5.0 server.
114 Novell Server Consolidation and Migration Toolkit Administration Guide
Section 11.6, "Migration Step 3: Begin NDS/eDirectory Migration," on
101.
down
copy c:\nwserver\expxeng.xlm c:\nwserver\novxeng.xlm
copy c:\nwserver\domxeng.xlm c:\nwserver\novxeng.xlm
NOTE: This might fail because domxeng.xlm is not present. This is not a problem.
If you used a directory other than \nwserver to store the server files, substitute that directory
for \nwserver in steps 2 and 3.
Need help?
Do you have a question about the SERVER CONSOLIDATION MIGRATION TOOLKIT 1.1 - ADMINISTRATION GUIDE 12-23-2005 and is the answer not in the manual?
Questions and answers