Table of Contents
Advertisement
Sentinel 6.1 Rapid Deployment
2
Control Center User Permissions
Sentinel
allows administrators to set user permissions in the Sentinel Control Center at a granular
TM
level. The only user created by default is the
created by the Sentinel Administrator, or someone with similar permissions.
The permissions in the User Manager are grouped into several major categories:
Each of these groups of settings are described in the following sections:
Section 2.1, "Changing User Permissions," on page 25
Section 2.2, "General," on page 27
Section 2.3, "Active Views," on page 28
Section 2.4, "iTRAC," on page 29
Section 2.5, "Incidents," on page 30
Section 2.6, "Integrators," on page 30
Section 2.7, "Actions," on page 31
Section 2.8, "Event Source Management," on page 31
Section 2.9, "Analysis Tab," on page 32
Section 2.10, "Administration," on page 32
Section 2.11, "Correlation," on page 33
Section 2.12, "Solution Pack," on page 33
Section 2.13, "Identity," on page 33
Section 2.14, "Reporting," on page 34
Section 2.15, "Downloading," on page 35
Section 2.16, "Java Webstart," on page 35
2.1 Changing User Permissions
1 Log into the Sentinel Control Center as a user with the User Management permissions.
2 Click the Admin tab.
3 Select User Configuration from Admin tab. Alternatively, Select User Manager from User
Configuration in the Navigator.
, or Sentinel Administrator. All other users are
admin
Sentinel 6.1 Rapid Deployment Control Center User Permissions
2
25
Advertisement
Table of Contents
