Installing Identity Assurance
3
Solution
This section describes or points to information on how to install all software components for the
Identity Assurance Solution.
IMPORTANT: The steps outlined in this section and in
Assurance Solution," on page 33
Section 3.1, "Installing the User Enrollment Biometric Capture Station," on page 21
Section 3.2, "Installing the Card Management System," on page 21
Section 3.3, "Installing the Physical Access Control System," on page 22
Section 3.4, "Installing the Identity Vault Server," on page 22
Section 3.5, "Installing Drivers," on page 24
Section 3.6, "Post-Installation Tasks," on page 29
Section 3.7, "Installing Workstations," on page 30
Section 3.8, "What's Next," on page 32
3.1 Installing the User Enrollment Biometric
Capture Station
The software being utilized for the User Enrollment Biometric Capture station for this release is
Honeywell SmartPlus Enrollment software. Make sure this software is installed on the machine you
are designating for this function.
For information on installing the Honeywell SmartPlus Enrollment software, see the installation
documentation provided by Honeywell.
3.2 Installing the Card Management System
The software being utilized for the Card Management System for this release is the ActivIdentity
CMS 4.0.3 software. Make sure this software is installed on the machine you are designating for this
function.
IMPORTANT: Patch # FISX0709018 is required and must be applied to ActivIdentity CMS 4.0.3.
For information on installing the ActivIdentity CMS software, see the installation documentation
provided by ActivIdentity.
Chapter 4, "Configuring Identity
must be performed in the order they are listed.
Installing Identity Assurance Solution
3
21