Novell BUSINESS CONTINUITY CLUSTERING FOR NETWARE 1.1 - ADMINISTRATION Manual page 36

IMPORTANT: In order to add or change cluster peer credentials, you must access iManager on a
server that is in the same eDirectory tree as the cluster you are adding or changing peer credentials
for.
1 In the Connections section of the Business Continuity Cluster Properties page, select the peer
2 Add the administrator username and password that the selected cluster will use to connect to
3 Repeat
4 Continue with
Adding Resource Script Search and Replace Values
To enable a resource for business continuity, certain values (such as IP addresses) specified in
resource load and unload scripts need to be changed in corresponding resources in the other clusters.
You need to add the search and replace strings that are used to transform cluster resource load and
unload scripts from this cluster to another cluster.
TIP: You can see the IP addresses that are currently assigned to resources by entering the display
secondary ipaddress command at the NetWare server console of cluster servers.
The search and replace data is cluster specific, and it is not synchronized via Identity Manager
between the clusters in the business continuity cluster.
To add resource script search and replace values:
1 In the Resource Script Replacements section of the Business Continuity Cluster Properties
2 Add the desired search and replace values, then click OK.
36 Novell Business Continuity Clustering 1.1 for NetWare Administration Guide
cluster, then click Edit.
In order for a cluster to appear in the list of possible peer clusters, that cluster must
Have Business Continuity Cluster software installed.
Have Identity Manager installed and running.
Have business-continuity-specific Identity Manager drivers configured and running.
Be enabled for business continuity.
the selected peer cluster.
When adding the administrator username, do not include the context for the user. For example,
bccadmin could be used instead of something like bccadmin.prv.novell.
NOTE: Rather than using the Admin user to administer your BCC, you should consider
creating another user with sufficient rights to the appropriate contexts in your eDirectory tree to
manage your BCC.
Step 1 and Step 2
Step 1 in the
page, click New.
The search and replace values you specify here apply to all resources in the cluster that have
been enabled for business continuity.
For example, if you specified 10.1.1.1 as the search value and 192.168.1.1 as the replace value,
the resource with the 10.1.1.1 IP address in its scripts would be searched for in the primary
cluster and, if found, the 192.168.1.1 IP address would be assigned to the corresponding
resource in the secondary cluster.
for the other cluster that this cluster will migrate resources to.
Adding Resource Script Search and Replace Values section below.