Updating Your Profiles - Novell APPARMOR 1.2 - QUICK GUIDE AND Installation & Quick Start Manual

TIP: For More Information
For more information about configuring event notification in Novell AppArmor,
refer to Section "Setting Up Event Notification" (Chapter 4, Managing Profiled
Applications, ↑Novell AppArmor Powered by Immunix 1.2 Administration Guide).
More information about report configuration can be found in Section "Reports"
(Chapter 4, Managing Profiled Applications, ↑Novell AppArmor Powered by
Immunix 1.2 Administration Guide).

4.4 Updating Your Profiles

Software and system configurations change over time. As a result of that your profile
setup for AppArmor might need some fine-tuning from time to time. AppArmor checks
your system log for policy violations or other AppArmor events and lets you adjust
your profile set accordingly. Any application behavior that is outside of any profile
definition can also be addressed using the Update Profile Wizard.
To update your profile set, proceed as follows:
1 Log in as root and start YaST.
2 Start Novell AppArmor → Update Profile Wizard.
3 Adjust access or execute rights to any resource or for any executable that has
4 Leave YaST after you answered all questions. Your changes are applied to the
TIP: For More Information
For more information about updating your profiles from the system logs, refer
to Section "Updating Profiles from Syslog Entries" (Chapter 3, Building Novell
AppArmor Profiles, ↑Novell AppArmor Powered by Immunix 1.2 Administration
Guide).
18
Delete unneeded reports or add new ones.
been logged when prompted.
respective profiles.