Advertisement
Figure 3.1 Enabling Novell AppArmor Using YaST
Using the YaST Runlevel tool, you enable services permanently—these settings survive
a reboot of your system. To enable AppArmor temporarily—for the duration of one
session only—proceed as follows:
1 Log in as root and start YaST.
2 Start Novell AppArmor → AppArmor Control Panel.
3 Set the AppArmor Status to AppArmor is enabled by clicking Configure → Enable
4 Apply your settings with Done.
12
→ OK.
Advertisement
Related Manuals for Novell APPARMOR 1.2 - QUICK GUIDE AND
Related Products for Novell APPARMOR 1.2 - QUICK GUIDE AND
- NOVELL BUSINESS CONTINUITY CLUSTERING 1.2.1 - ADMINISTRATION
- NOVELL BUSINESS CONTINUITY CLUSTERING 1.0 - ADMINISTRATION
- NOVELL BUSINESS CONTINUITY CLUSTERING FOR NETWARE 1.1 - ADMINISTRATION
- NOVELL BUSINESS CONTINUITY CLUSTERING 1.1 SP2 - ADMINISTRATION
- NOVELL DATA SYNCHRONIZER - UPDATE 1
- NOVELL LINUX ENTERPRISE DESKTOP 11 - KDE
- NOVELL LINUX ENTERPRISE SERVER 10 SP1 - ARCHITECTURE-SPECIFIC INFORMATION 15-05-2007
- NOVELL ZENWORKS 10 ASSET MANAGEMENT SP3 - MIGRATION GUIDE 10.3 23-03-2010
- NOVELL ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - PREBOOT SERVICES AND IMAGING REFERENCE 10.3 16-04-2010
- NOVELL ZENWORKS 7.2 LINUX MANAGEMENT - SCENARIOS 1 03-30-2007
- Novell SUSE LINUX ENTERPRISE DESKTOP 10 SP1 KDE
- Novell LINUX ENTERPRISE SERVER 11 SUSE
- Novell LINUX ENTERPRISE 10 SP1 - LINUX AUDIT
- NOVELL OPEN WORKGROUP SUITE SMALL BUSINESS EDITION 9.3 - ADMINISTRATION 10-2007
- NOVELL ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - COMMAND LINE UTILITIES REFERENCE 10.3 30-03-2010
- NOVELL LINUX ENTERPRISE SERVER 10 SP3 - ARCHITECTURE-SPECIFIC
Need help?
Do you have a question about the APPARMOR 1.2 - QUICK GUIDE AND and is the answer not in the manual?