Novell APPARMOR 1.2 - QUICK GUIDE AND Installation & Quick Start Manual page 17

1 Make sure that a mail server is running on your system to deliver the event noti-
fications.
2 Log in as root and start YaST. Then select Novell AppArmor → AppArmor
Control Panel ).
3 In Enable Security Event Notification section, select Configure.
4 For each record type (Terse, Summary, and Verbose) set a report frequency, enter
the e-mail address to receive the reports and determine the severity of events to
log. If you want to include unknown events in the event reports, check Include
Unknown Severity Events.
NOTE
Unless you are familiar with AppArmor's event categorization, choose to
be notified about events for all security levels.
5 Leave this dialog with OK → Finish to apply your settings.
Configure Novell AppArmor reports. Using reports, you can read important Novell
AppArmor security events reported in the log files without manually sifting through
the cumbersome messages only useful to the logprof tool. You can decrease the size
of the report by filtering by date range or program name.
To configure the AppArmor reports, proceed as follows:
1 Log in as root and start YaST. Select Novell AppArmor → AppArmor Reports.
2 Select the type of report you want to examine or configure from Executive Secu-
rity Summary, Applications Audit, and Security Incident Report.
3 Edit the report generation frequency, e-mail address, export format, and the loca-
tion of the reports by selecting Edit and providing the requested data.
4 To run a report of the selected type, click Run Now.
5 Browse through the archived reports of a given type by selecting View Archive
and specifying the report type.
or
Getting Started with Profiling Applications 17