Performing Component-Specific Procedures - Novell ACCESS MANAGER 3.1 SP1 - ADMINISTRATION Manual

6.7.5 Performing Component-Specific Procedures

If you have installed the following components, perform the cleanup steps for the component:
"Third Administration Console" on page 98
"Linux Access Gateways" on page 98
"Linux Identity Server" on page 100
"Windows Identity Server" on page 101
"Linux J2EE Agents" on page 101
"Windows J2EE Agents" on page 101
"SSL VPN" on page 102
"Old Primary Administration Console" on page 103
Third Administration Console
If you installed a third Administration Console used for failover, you must manually perform the
following steps on that server:
1 Open the
Linux:
Windows:
2 In the file, look for the line that is similar to the following:
<vcdnPrimaryAddress>10.1.1.1</vcdnPrimaryAddress>
In this line, 10.1.1.1 represents the failed primary Administration Console IP address.
3 Change this IP address to the IP address of the new primary Administration Console.
4 Restart the Administration Console by entering the following command from the command
line interface:
Linux:
Windows:
Then,
Linux Access Gateways
For each Linux Access Gateway imported into the Administration Console, you must edit the
config.xml
config and working config XML documents in the configuration store on the new primary
Administration Console.
1 At the Linux Access Gateway, log in as the
2 Open a terminal window and shut down all services by entering the following commands:
/etc/init.d/novell-jcc stop
/etc/init.d/novell-tomcat5 stop
/etc/init.d/novell-vmc stop
3 If you are running SSL VPN, enter the following command to stop SSL VPN:
/etc/init.d/novell-sslvpn stop
98 Novell Access Manager 3.1 SP1 Administration Console Guide
file.
vcdn.conf
/opt/novell/devman/share/conf
C:\Program Files\Novell\Tomcat\webapps\roma\WEB-INF\conf
/etc/init.d/novell-tomcat5 restart
net stop Tomcat5
net start Tomcat5
file and the
settings.properties
file on the Access Gateway and edit the current
user.
root