Related Manuals for Black Horse Off Road PR-JPGC79
Summary of Contents for Black Horse Off Road PR-JPGC79
- Page 1 #PR-JPGC79 INSTALLATION INSTRUCTIONS PART # PR-JPGC79 1-866-926-2867 | 39 St. Mary’s Place, Freeport, NY 11520 | Page 1 of 5 www.blackhorseoffroad.com...
- Page 2 #PR-JPGC79 PARTS LIST: Driver/Left Running Board 10mm Lock Washers Passenger/Right Running Board 10mm x 50mm Hex Bolts Driver/Left Front Mounting Bracket 10mm x 40mm Hex Bolt Passenger/Right Front Mounting Bracket 10mm Hex Nut Driver/Left Center Mounting Bracket 10mm Threaded Insert...
- Page 3 #PR-JPGC79 8. Move to the Passenger/Right side. Repeat Steps 2,3 & 5 to attach the Passenger/Right Front and Rear Mounting Brackets. 9. Locate the center mounting location, (Figure 9). Select the Passenger/Right Center Mounting Bracket. Hold the Bracket and line up to the hole in the pinch trim to the lower slot in the top of the Bracket. Mark where the top slot is located on the floor panel.
- Page 4 #PR-JPGC79 Driver Side Installation Pictured 12mm threaded insert 10mm threaded insert Rear Front (Fig 4) Driver/Left center mounting location (Fig 5) Driver/Left rear mounting location. The threaded insert is smaller than the front and center locations 10mm Hex Bolt 10mm Lock Washer...
- Page 5 #PR-JPGC79 Passenger Side Installation Pictured (Fig 9) Locate the Passenger/Right center mounting location. Line up the top of the Passenger/Right Center Mounting Bracket to the hole in the pinch trim. Mark the top slot for drilling. Use a 1/2” drill bit, not included (10-A) Select Insert Tool and (1) Insert.
Need help?
Do you have a question about the PR-JPGC79 and is the answer not in the manual?
Questions and answers