MOLBOX1+™/MOLBOX1+S, MOLBLOC TERMINAL OPERATION AND MAINTENANCE MANUAL
3.4.6.7
To activate the FREEZE DISPLAY.
To activate the FREEZE DISPLAY press [DISPLAY] and select <7freeze>.
Selecting <7freeze> returns to the MAIN run screen with the FREEZE DISPLAY active.
With the FREEZE DISPLAY active, the MAIN run screen is:
Pressing [ENTER] causes the current flow measured by the active molbox1+
range to be captured and displayed.
3.4.6.8
To activate the CLEAN DISPLAY.
To activate the CLEAN DISPLAY press [DISPLAY] and select <8clean>.
Selecting <8clean> returns to the MAIN run screen with the CLEAN DISPLAY active.
With the CLEAN DISPLAY active, the MAIN run screen is:
© 1995 - 2010 Fluke Corporation, DH Instruments Division
<7Freeze>
PURPOSE
See Section 3.4.6, PRINCIPLE.
OPERATION
1.
Standard MAIN run screen top line.
2.
Flow measured in the current flow units when
[ENTER] was pressed (displays 0.00 by default
when FREEZE DISPLAY is first activated).
•
If the flow measurement unit is changed while the FREEZE
DISPLAY is active, the FREEZE value defaults back to zero.
•
The set point of the optional MFC function cannot be
changed in the FREEZE display because [ENTER] is used by
the DISPLAY function. MFC set point can only be entered in
the RATE, UNIT or CLEAN DISPLAY functions.
•
To go to a DISPLAY other than FREEZE, press [DISPLAY]
and make a new DISPLAY choice.
<8Clean>
PURPOSE
See Section 3.4.6, PRINCIPLE.
OPERATION
1.
Standard MAIN run screen top line.
2.
"Clean" second line.
Page 80
Note
* 101.75 sccm
F 99.24
Note
Note
* 101.45 sccm
N20
N2O