Table of Contents
Advertisement
MOLBOX1+™/MOLBOX1+S, MOLBLOC TERMINAL OPERATION AND MAINTENANCE MANUAL
OPERATION
To access the reset choices press [SPECIAL] and select
<1reset>. The display is:
Select the desired reset. After confirmation, the reset occurs. A reset always puts the
molbox1+ through its start up routine as if power had been turned OFF and back ON.
See Sections 3.6.1.1 through 3.6.1.5 for detailed information on the specific reset choices.
RESET functions change user settings that affect flow measurement. If
not used properly, resetting can cause out of tolerance measurements.
RESET functions should only be used by qualified personnel with
reference to this manual for information on the RESET functions.
3.6.1.1
To access Reset - Sets, press [SPECIAL] and select <1reset>, <1sets>.
Reset - Sets clears and sets to default the user settings for various measurements.
These include:
•
•
•
•
•
•
•
•
•
•
•
•
3.6.1.2
To access Reset - Units, press [SPECIAL] and select <1reset>, <2units>.
Reset - Units clears and sets to default all UNIT OF MEASURE functions. These include:
•
•
•
•
© 1995 - 2010 Fluke Corporation, DH Instruments Division
<1sets>
PURPOSE/OPERATION
Flow unit of measure to sccm (see Section 3.4.3).
Pressure unit of measure to kPa (see Section 3.5.8).
Temperature unit of measure to °C (see Section 3.5.9).
Gas type to N2 (see Section 3.4.2).
Stability criterion to 0.1 sccm (see Section 3.5.2).
K factor to 1 (see Section 3.4.1).
DISPLAY function to Rate (see Section 3.4.6.1).
RPT Tare value to 0 (see Section 3.4.4.1.1).
Tare to upstream pressure (see Section 3.4.4.1.1).
Flow adder to 0 and flow multiplier to 1 (see Section 3.5.3).
Resolution to 0.001 % (see Section 3.4.9).
BPR mode to Auto (see Section 3.6.9)
<2units>
PURPOSE/OPERATION
Six flow units of measure selectable from [UNIT] to defaults (see Section
3.4.3).
Flow unit of measure to sccm (see Section 3.4.3).
Reference temperature for uxxx units of measure to 0 °C (see
Section 3.4.3.3).
Volume flow unit of measure conditions to molbloc for temperature and
standard atmospheric pressure for pressure (see Section 3.4.3.4).
Page 96
1sets 2units 3mfc
4cal 5all
Note
Advertisement
Table of Contents
