NETGEAR DGND3800B User Manual page 108

N600 Wireless Dual Band Gigabit VDSL2 Modem Router DGND3800B
c. Rename the new connection so that it matches the Connection Name field in the
VPN Settings screen of the modem router on LAN A. Choose connection names that
make sense to the people using and administering the VPN.
In this example, the connection name used on the client side of the
Note:
VPN tunnel is togw_a, and it does not have to match the
RoadWarrior connection name used on the gateway side of the VPN
tunnel because connection names are irrelevant to how the VPN
tunnel functions.
d. Enter the following settings:
Connection Security. Select Secure.
•
ID Type. Select IP Subnet.
•
Subnet. In this example, type 192.168.3.1 as the network address of the modem
•
router.
Mask. Enter 255.255.255.0 as the LAN subnet mask of the modem router.
•
Protocol. Select All to allow all traffic through the VPN tunnel.
•
e. Select the Connect using Secure Gateway Tunnel check box.
f. In the ID Type drop-down list, select IP Address.
g. Enter the public WAN IP address of the modem router in the field directly below the
ID Type drop-down list. In this example, 22.23.24.25 is used.
The resulting connection settings are shown in the figure that follows.
Configure the security policy in the NETGEAR ProSafe VPN Client software:
3.
a. In the Network Security Policy list, expand the new connection by double-clicking its
name or clicking the + symbol. My Identity and Security Policy subheadings appear
below the connection name.
Virtual Private Networking
108