Hydrel Wander3 SRM Installation Manual

Installation Guide
READ AND FOLLOW ALL SAFETYINSTRUCTIONS!
SAVE THESE INSTRUCTIONS AND DELIVER TO OWNER AFTERINSTALLATION
aged during transit. Inspect to confirm. Any part damaged or broken during or after assembly should be replaced.
RISK OF ELECTRIC SHOCK
✓ Disconnect or turn off power before installation or
servicing.
✓ Verify that supply voltage is correct by comparing it
with the luminaire label information.
✓ Make all electrical and grounded connections in
accordance with the National Electrical Code
(NEC) and any applicable local code requirements.
✓ All wiring connections should be capped with UL
approved recognized wire connectors.
RISK OF INJURY
✓ Wear gloves and safety glasses at all times when
removing luminaire from carton, installing, servic-
ing or performing maintenance.
✓ Avoid direct eye exposure to the light source while
it is on.
NOTE: HYDREL RESERVES THE RIGHT TO MODIFY SPECIFICATION
WITHOUT NOTICE.
Any dimension on this sheet is to be assumed as a reference dimension:
"Used for information purposes only. It does not govern manufacturing or
inspection requirements." (ANSI Y14.5-1973)
WARNING
CAUTION
WANDER SRM BACK BOX
WARNING
RISK OF BURN
✓ Allow lamp/fixture to cool before handling. Do not
touch enclosure or light source.
✓ Do not exceed maximum wattage marked on lumi-
naire label.
✓ Follow all manufacturer's warnings, recommenda-
tions and restrictions for: driver type, burning po-
sition, mounting locations/methods, replacement
and recycling.
CAUTION
RISK OF FIRE
✓ Keep combustible and other materials that can
burn, away from lamp/lens.
✓ Do not operate in close proximity to persons, com-
bustible materials or substances affected by heat
or drying.
©2020 Acuity Brands Lighting Inc.| One Lithonia Way, Conyers GA. 30012
Phone: 800-705-SERV (7378) | www.hydrel.com
1
WNRBB-1 | 12-11-24 | REV A