Related Manuals for Fisher & Paykel JZT-CG301DNGGB5
Summary of Contents for Fisher & Paykel JZT-CG301DNGGB5
- Page 1 GAS-ON-GLASS COOKTOP JZT-CG301DNGGB5, JZT-CG301DNGGG5, JZT-CG391DNGGB5 & JZT-CG391DNGGG5 models USER GUIDE...
-
Page 3: Table Of Contents
CONTENTS Safety and warnings First use Manual lighting Burner parts Burner accessories Cookware guide Care and cleaning Leak testing Troubleshooting Manufacturer’s Warranty and Service guide... -
Page 5: Safety And Warnings
SAFETY AND WARNINGS WARNING! Electrical Shock Hazard Failure to follow this advice may result in electrical shock or death. • Switch the power to the cooktop off at the wall before cleaning or maintenance. • Connection to a good earth wiring system is essential and mandatory. - Page 6 SAFETY AND WARNINGS WARNING! Poisoning Hazard Failure to follow this advice may result in poisoning or death. • Never use this appliance as a space heater to heat or warm the room. Doing so may result in carbon monoxide poisoning and overheating of the appliance.
- Page 7 SAFETY AND WARNINGS READ AND SAVE THIS GUIDE WARNING! To reduce the risk of fire, injury to persons or damage when using the appliance, follow the important safety instructions listed below. Read all the guidance before installing or using the appliance. Installation This is a Type A gas appliance.
- Page 8 SAFETY AND WARNINGS If the electrical supply cord is damaged, it must only be replaced by an authorised person. If the appliance is connected to the gas supply with a flexible hose, make sure that the hose cannot come in contact with the bottom of the appliance or any sharp edges. Ensure that the electrical connection plug is accessible after installation.
-
Page 9: First Use
FIRST USE Cooktop features and accessories 1 Burner 2 Trivet 3 Control dial 4 Small pan support 5 Wok stand 6 Serial label (on cooktop base) - Page 10 FIRST USE When using the burner, you can choose to use the inner burner only or both the inner and outer burners as desired. Inner burner only Lighting the burner Push the dial down and turn counterclockwise to the highest heat setting. Once the burner is lit, hold the dial down for a further 3 seconds.
-
Page 11: Manual Lighting
MANUAL LIGHTING If the burner will not light after several attempts, the burner can be manually lit. If you have attempted to light the burner with the ignition, allow 5 minutes for any accumulated gas to dissipate before manually lighting. Lighting your cooktop this way can be achieved if your power is off. -
Page 12: Burner Parts
BURNER PARTS Burner cap Burner ring Ensure all parts are correctly Correct alignment fitted before using the burner. Flame Flames should burn blue, spreader without yellow tips or fluttering Ignitor around the burner cap. Probe Burner skirt Incorrect alignment do not remove Ensure the trivet is securely positioned and level. -
Page 13: Burner Accessories
BURNER ACCESSORIES Small pan support Use the small pan support for cookware with a base diameter smaller than 200mm. Using the small pan support Ensure the cooktop is cool before positioning the small pan support on the centre of the trivet. Ensure the support is securely positioned and level before using. -
Page 14: Cookware Guide
COOKWARE GUIDE For optimal performance, ensure the size of the cookware is suitable for the burner in use. MIN. DIAMETER MAX. DIAMETER BURNER Pan without small pan support Dual wok Wok with wok stand Note: measurements provided from base of pan... -
Page 15: Care And Cleaning
CARE AND CLEANING When cleaning your cooktop, switch the power off at the wall. We do not recommend using the following cleaning products as they may cause damage: Plastic or stainless steel scouring pads Abrasive or solvent cleaners Acid or alkaline cleaners Stainless steel cleaners or polishes Laundry detergents or disinfectants Everyday cleaning such as fingerprints, marks, metal sheen and non-sugary spills... -
Page 16: Leak Testing
LEAK TESTING Follow the below instructions to carry out leak testing: Ensure all dials are set to before connecting cooktop to gas supply. After final gas connection is made, turn gas supply on and test all connections in gas supply piping for gas leaks with a soapy water solution. In order to avoid property damage or serious personal injury, never use a match or open flame. -
Page 17: Troubleshooting
TROUBLESHOOTING Why won’t my cooktop turn on? There may be no power. Make sure the cooktop is connected to the power supply and switched on at the wall. Check the circuit breaker, or check if there is a power cut in your home or area. - Page 18 TROUBLESHOOTING The flame has been extinguished The flame may have been blown out by draught. In this case, the flame failure protection will automatically cut the gas supply to the burner off, stopping gas from escaping. The flame may have been extinguished by a spill. Turn the burner off, then wait for at least 5 minutes before attempting to relight.
-
Page 19: Manufacturer's Warranty And Service Guide
MANUFACTURER’S WARRANTY AND SERVICE GUIDE To access your Warranty and Service Guide Scan the QR code with your smartphone to access your warranty and book a service, or view online at https://www.fisherpaykel.com/cn/ help-and-support/warranty-information This product has been designed for use in a domestic (residential) environment. This product is not designed for any commercial use. - Page 20 FISHERPAYKEL.COM © Fisher & Paykel Appliances 2025. All rights reserved. The models shown in this guide may not be available in all markets and are subject to change at any time. The product specifications in this guide apply to the specific products and models described at the date of issue.
Need help?
Do you have a question about the JZT-CG301DNGGB5 and is the answer not in the manual?
Questions and answers