Dacor DMT2420 Planning Manual

Document # PGCI - 018
All tolerances: +1/16", -0, (+1.6 mm, -0) unless otherwise stated
1
58 3/4"
Min.
(1492 mm)
overall
stacked
height
1
1

CUTOUT DIMENSIONS

NOTE:
1. 3/4" (19 mm) support platform (flush with cutout).
2. See individual appliance Planning Guide pages to
determine overlays.
3. Spacing between appliances and drawers/doors shown
is minimum required to allow for ventilation and prevent
scraping. Additional space may need to be added for
appearance.
4. Warming drawer model OWD24 is not approved for
installation below a wall oven.
Microwave
Model No.
DMT2420 w/AOMTK series trim kit
DCM24 w/AOCTK27 trim kit
DCM24 w/AOCTK30 trim kit
www.Dacor.com
Phone: (800) 793-0093

COMBINATION INSTALLATIONS

Microwave/Discovery Wall Oven/
Warming Drawer
7/8" Min. (22 mm)
120 Vac electrical
outlet for microwave
(425 mm)
A
240 Vac
wall oven
junction box
B
(699 mm)
C
120 Vac electrical
outlet for warming
(232 mm)
drawer
DMT2420 ShOWN
(A) Cutout Width
24 3/8" (619 mm)
25 1/4" (641 mm)
25 1/4" (641 mm)
• Observe all governing codes and ordinances during
planning and installation. Contact your local building
department for further information.
• All appliances must be installed in accordance with the
accompanying installation instructions.
16 3/4"
1 1/2" Min.
(38 mm)
27 1/2"
60 3/4"
Min.
(1543 mm)
2 1/4" Min.
overall
(57 mm)
stacked
9 1/8"
height
3/4" Min.
(19 mm)
Wall Oven
(B) Cutout Width
Models
Single 27" 25 1/2" (648 mm)
Single 30" 28 1/2" (724 mm)
Specifications are subject to change without notice.
See installation instructions for additional details.
Revised 11/05/09 Page 1/1
PLANNING
GUIDE
WArNING
A
120 Vac electrical
outlet for microwave
1
240 Vac
wall oven
junction box
B
1
C
120 Vac electrical
outlet for warming
1 drawer
CUTOUT DIMENSIONS
DCM24 ShOWN
Warming
Drawer (C) Cutout Width
Models
27" 25 1/2" (648 mm)
30" 28 1/2" (724 mm)
7/8" Min. (22 mm)
18 1/2"
(470 mm)
1 3/4" Min.
(44 mm)
27 1/2"
(699 mm)
2 1/4" Min.
(57 mm)
9 1/8"
(232 mm)
3/4" Min.
(19 mm)
CI.22