Onkyo HT-S6500 Instruction Manual page 81

5.1ch Home Theater Speaker Package
Supplied Accessories
Make sure you have the following accessories.
Front speakers (SKF-680)
(White)
Front speakers Speaker cables 11 ft. (3.5 m)
20 rubber stoppers *1
(For Front/Center/
Surround speakers)
*1 Configuration of the rubber stoppers may be different from the
figure, such as being 2 sheets instead of 1 sheet, but the total
number will be same.
Center speaker (SKC-680)
Center speaker Speaker cable 10 ft. (3.0 m)
Surround speakers (SKR-680)
(Blue)
Surround speakers Speaker cables 26 ft. (8.0 m)
HTP-691
E
n
Powered subwoofer (SKW-791)
(Red)
Subwoofer
4 floor pads
Part Names
(Green)
SKC-680
(Gray)
RCA cable 10 ft. (3.0 m)
Keyhole slot
Speaker terminals
SKF-680/SKR-680
Speaker terminals
Keyhole slots
En-1
Caution
• The front grilles are not designed to be removed so do not
attempt to remove them forcibly, as this will damage
them.
■
Front
Status indicator
Off: Subwoofer in standby mode or
disconnected from power source
Blue: Subwoofer on
With the Auto Standby function, the
SKW-791 automatically turns on when an
input signal is detected in standby mode.
When there's no input signal for a while,
the SKW-791 automatically enters
SKW-791
standby mode.
■
Rear
OUTPUT LEVEL control
This control is used to adjust the
volume of the subwoofer.
LINE INPUT
SKW-791
This RCA input should be
To AC outlet connected to the subwoofer pre
out on your AV receiver with
supplied RCA cable.
Note
• The Auto Standby function turns the subwoofer on when the
input signal exceeds a certain level. If the Auto Standby function
does not work reliably, try slightly increasing or decreasing the
subwoofer output level on your receiver.