Netscape MANAGEMENT SYSTEM 6.01 - PLUG-IN Manual page 71

Figure 2-3
Table 2-3 gives details for each of these parameters.
Description of parameters defined in the RequestInQJob module
Table 2-3
Parameter
enabled
cron
subsystemid
Parameters defined in the RequestInQJob module
Description
Specifies whether the job is enabled or disabled. Check the box to enable the
job. Uncheck the box to disable the job. If you enable the job and set the
remaining parameters correctly, the server runs the job at scheduled intervals.
Specifies the cron specification for when this job should be run. This is the
time at which the Job Scheduler daemon thread checks the queue for pending
requests.
Permissible values: Must follow the convention specified in "Schedule for
Executing Jobs" on page 76.
Example: 00**0
Specifies the subsystem that this job is for.
Permissible values: ca or ra.
• ca specifies that the job is for the Certificate Manager.
• ra specifies that the job is for the Registration Manager.
Example: ca
RequestInQJob Plug-in Module
Chapter 2 Job Plug-in Modules 71