Netscape MANAGEMENT SYSTEM 6.01 - PLUG-IN Manual page 306

NTEventLog Plug-in Module
Figure 8-3
Table 8-3 gives details about each of these parameters and their values.
Table 8-3 Description of parameters defined in the NTEventLog module
Parameter
type
enable
level
NTEventSourceName
306 Netscape Certificate Management System Plug-Ins Guide • May 2002
Parameters defined in the NTEventLog module
Description
Specifies the log (or event) type.
Permissible values: audit or system. Select audit for audit logs and
system for error and system logs.
Example: system
Specifies whether the listener is enabled to log messages.
you want the server to log messages
• Check the box if
• Leave the box unchecked if you do not want the server to log messages of
this type.
a message category that represents the level of logging to
Specifies
filter messages
. For details, see section "Log Levels (Message Categories)" in
Chapter 23, "Managing CMS Logs" of CMS Installation and Setup Guide.
Permissible values: Debug, Info, Warning, Failure, Misconfiguration,
Catastrophe, and Security.
Example: Info
Specifies the name of the CMS instance that's logging the messages.
.
of this type