Upgrading From Directory Server 6.0X Versions; Before You Begin; Upgrading - Netscape DIRECTORY SERVER 6.1 Installation Manual

Upgrading From Directory Server 6.0x Versions

serverRoot/shared/config/dbswitch.conf:directory default
ldap://configHostname:configPort/o%3DNetscapeRoot
serverRoot/slapd-serverID/config/dse.ldif:nsslapd-pluginarg0:
ldap://configHostname:configPort/o%3DnetscapeRoot
Turn off the pass through authentication (PTA) plug-in on Server2 by editing
3.
its
a.
b.
c.
Restart the Directory Server and Administration Server.
4.
Upgrading From Directory Server 6.0x Versions
You can upgrade an instance of Directory Server 6.0x (for example, 6.0, 6.01, or
6.02) to Directory Server 6.1 by installing Directory Server 6.1 into the same
installation directory in which your 6.0x Directory Server instance is installed. This
section explains the upgrade process in these sections:
•

Before You Begin

•

Upgrading

• After You Upgrade
Before You Begin
Before you begin the upgrade process, back up your entire legacy Directory Server.
For instructions, check backing up and exporting related topics in Chapter 4,
Populating Directory Databases" of the Netscape Directory Server Administrator's
Guide.
Upgrading
The steps below show how to perform an upgrade using the typical mode of
installation on UNIX:
94 Netscape Directory Server Installation Guide • August 2002
f file.
dse.ldi
In a text editor, open the
Locate the entry for the the PTA plug-in :
dn: cn=Pass Through Authentication,cn=plugins,cn=config
Change
nsslapd-pluginEnabled: on
serverRoot/slapd-serverID/config/dse.ldif
to
nsslapd-pluginEnabled: off
file.
.