Master Migration; Hub Migration - Netscape DIRECTORY SERVER 6.1 Installation Manual

Migration Procedure
Migrate the first master; see section "Master Migration," on page 92.
3.
Verify that writes and changes are being replicated through the servers.
4.
Migrate the second master; see section "Master Migration," on page 92.
5.
Verify that writes and changes are being replicated through the servers.
6.
Migrate the hubs (if any); see section "Hub Migration," on page 92.
7.
Verify that writes and changes are being replicated through the servers.
8.
Migrate the consumers; see section "Consumer Migration," on page 93.
9.
Verify that writes and changes are being replicated through the servers.
10.

Master Migration

Follow these steps for the first master and then, repeat the steps for the second:
Stop the 5.x Directory Server.
1.
Install Directory Server 6.x.
2.
Make this your configuration instance, as it is not replicated. For the second
master, register against the first master's configuration instance.
Log into console and create a new instance that you are going to migrate to.
3.
This instance will need to be created to listen on the port that your standard
access will be to (usually 389).
Run the migration script following the instruction in "Migrating a Standalone
4.
Server," on page 80.
Once your master is migrated, test replication and make sure that it is working
5.
correctly.
After you finish this process for the first master, repeat the steps for the second
6.
master.
You may wish to set up multi-master replication for
the instances on the masters.

Hub Migration

To migrate a 5.x hub:
Stop your Directory Server 5.x.
1.
92 Netscape Directory Server Installation Guide • August 2002
between
o=NetscapeRoot