Red Hat LINUX 7.2 - OFFICIAL LINUX CUSTOMIZATION GUIDE Manual page 41

Section 1.5:Kickstart Options
1.5.26 upgrade
upgrade (optional)
Tells the system to upgrade an existing system rather than install a fresh system.
1.5.27 xconfig
xconfig (optional)
Configures the X Window System. If this option is not given, the user will need to configure X
manually during the installation, if X was installed; this option should not be used if X is not
installed on the final system.
--noprobe
Do not probe the monitor.
--card <card>
Use card <card>; this card name should be from the list of cards in Xconfigurator. If
this argument is not provided, Anaconda will probe the PCI bus for the card. Since
AGP is part of the PCI bus, AGP cards will be detected if supported. The probe order is
determined by the PCI scan order of the motherboard.
--videoram <vram>
Specify the amount of video RAM the video card has.
--monitor <mon>
Use monitor <mon>; this monitor name should be from the list of monitors in Xconfig-
urator. This is ignored if --hsync or --vsync is provided. If no monitor information
is provided, the installation program tries to probe for it automatically.
--hsync <sync>
Specifies the horizontal sync frequency of the monitor.
--vsync <sync>
Specifies the vertical sync frequency of the monitor.
--defaultdesktop=GNOME or --defaultdesktop=KDE
Sets the default desktop to either GNOME or KDE (and assumes that GNOME and/or
KDE has been installed through %packages).
--startxonboot
Use a graphical login on the installed system.
1
41