pyrexx PX-1C Quick Reference Manual

P X - 1C
The Quick Reference Guide is not a su
P X - 1C
essential to read and observe the oper
the safety instructions and information
The Quick Reference Guide is not a substitute for the operating manual. It is
essential to read and observe the operating manual. Pay attention especially to
alarm device with radio link contained
the safety instructions and information on the usage and operation of the smoke
alarm device with radio link contained therein.
1 Controls
1 Controls
1 Splint pin (activation backup)
2 Activation button
3 Magnetic carrier
4 Signal LED
5 Radio button
6 Smoke intake lamella
7 Testing / stop button
(smoke alarm device cover)
2 Set up radio group
The first device placed
•
1 Splint pin (activation backup)
into service is master
Installation at a central location
•
2 Activation button
in the house or apartment
(1) Remove magnetic carrier from
3 Magnetic carrier
the device
(2) Push the splint pin sideways off of
the activation button
4 Signal LED
(3) Push activation button flush
5 Radio button
short acoustic signal
6 Smoke intake lamella
5 No other device is in learning
7 Testing / stop button
mode
(4) Press and hold the radio button
(smoke alarm device cover)
with splint pin until:
Quick Reference Guide
1
2
3
4
5
6
7
Quick Reference Guid
Smoke Alarm Device with Radio Link
5 Device max. 10 minutes in
learning mode
3 Expand radio group
(learning mode)
Installation place min. 2 m
•
away from another device
f Push activation button flush
short acoustic signal
5 Device max. 10 minutes in lear-
ning mode
4 Finalising radio group
f Wait 10 minutes
f or briefly push the radio button
on the device last put into
operation until:
all signal LEDs „off"
5 Radio group is in operation
f To verify, perform the connection
test (see section "Group connec-
tion test")
5 Bring the radio group
into learning mode
(1) Press and hold the radio button
with splint pin on any device until:
signal LED „off"
(2) Release radio button
1
2
3
device is added
4
5
6
7