WANDERS KANDA Users Manual & Installation page 25

Illustration 1 Removing the flue collar from the
stove
Illustration 2 Placing the energy-saving valve and the
push rod.
Illustration 3 Placing the baffle into the stove
Illustration 4 Placing the model tag
7. Connect the flue to the flue collar; then remount the
flue collar on the hearth.
8. Then build the mantelshelf around it; please re-
member to use only non-combustible materials.
9. Place the convection grates on the right and left
sides of the fireplace.
10. Connect the flexible convection tubes to the mouths
of the convection tubes. Mount the tube mouths on
the hearth. You must install them to ensure proper
heat output of the stove and to prevent the walls
from cracking.
11. Connect the lower two tubes to the ventilation
ducts. If the room is mechanically ventilated or
equiped with a heat recovery system connect the
duct to the outside air by using additional tubes. In
the last situation also connect the upper two tubes
to the outside air. (see illustration 6).
12. Mount the energy-saving baffle and place the push
rod into the recess in the front of the stove's door.
Hang the valve on the hooks of the hinges (see il-
lustration 2).
13. Place the flue gas regulator on the supports under-
neath the energy-saving valve (see illustration 3)
14. If necessary, replace the model tag with the model
tag in your language. (illustration 4))
15. Then close the front side of the chimney cover with
a 20 mm promatec H plate and ensure that the plate
does not make any contact with the hearth on the
inside.
16. Please remember to put the stucco frames around
the opening of the hearth to prevent cracking. Nev-
er attach the stuccowork to the hearth but always
leave 3 mm open around the built-in frame and the
stucco frames.
25