Advertisement
Table of Contents
2190 Boul. Dagenais West
LAVAL (QUEBEC)
CANADA
H7L 5X9
Your pump has been
carefully
packaged
the factory to prevent
damage during shipping.
However,
damage may occur due to
rough handling. Carefully
nspect your pump for
i
damages
that
cause failures. Report
any
damage
carrier or your point
of purchase.
2003 BUR-CAM Printed in Canada 350134P
W W W. B U R C A M . C O M
TEL: 514.337.4415
FAX: 514.337.4029
info@burcam.com
at
occasional
could
to
your
INSTALLATION
INSTRUCTIONS
MODEL
300700P
SUMP PUMPS
Please read these
carefully. Failure
instructions and
instructions
to comply to
designed
operation of
this system,
may void
the
warranty.
Advertisement
Table of Contents
Related Manuals for Burcam 300700P
Summary of Contents for Burcam 300700P
- Page 1 W W W. B U R C A M . C O M 2190 Boul. Dagenais West TEL: 514.337.4415 MODEL LAVAL (QUEBEC) FAX: 514.337.4029 CANADA 300700P H7L 5X9 info@burcam.com Your pump has been carefully packaged SUMP PUMPS the factory to prevent damage during shipping.
-
Page 2: Safety Instructions
SAFETY INSTRUCTIONS: This fine pump that you have just purchased is designed from the latest in material and workmanship. Before installation and operation, we recommend the following procedures: CHECK WITH YOUR LOCAL ELECTRICAL AND PLUMBING CODES TO ENSURE YOU COMPLY WITH THE REGULATIONS. THESE CODES HAVE BEEN DESIGNED WITH YOUR SAFETY IN MIND. -
Page 3: Installation Steps
APPLICATION FEATURES ❏ This submersible sump pump is designed for a ❏ permanent sump installation. Non corrosive material. ❏ For dewatering around homes and farms. It can be used in light commercial ❏ Stainless steel mechanical rotary seal. application. FRICTION LOSS IN ❏... -
Page 4: Maintenance
SUMP PUMP APPLICATION SEE DIAGRAM ON PAGE 5 At this step, you have the opportunity to install a 1 1/2” or a 1 1/4” discharge. We recommend STEP 3 a 1 1/2” ABS/DWV discharge. Install a check valve (350362 in-line 1 1/2” or 350353 1 1/4” MNPT inlet and 1 1/4”... -
Page 5: Repair Parts
SUMP PUMP APPLICATION STEP 3 Prepare your choice of discharge pipe size and check valve STEP 2 Sump pit 18” diameter X STEP 6 25” depth Connect float and motor power cable STEP 7 STEP 5 Fill the basin and Install discharge test the operation pipe... - Page 6 TROUBLE SHOOTING GUIDE CHECKLIST NEVER MAKE ADJUSTMENTS TO ANY ELECTRICAL APPLIANCE OR PRODUCT WITH THE POWER CONNECTED. DON’T JUST UNSCREW THE FUSE OR TRIP THE BREAKER, REMOVE THE POWER FROM THE RECEPTACLE. TROUBLE PROBABLE CAUSE ACTION Switch is off position Turn switch to on position Motor does not Replace...
Need help?
Do you have a question about the 300700P and is the answer not in the manual?
Questions and answers