Table of Contents
Related Manuals for bynav T1
Summary of Contents for bynav T1
- Page 1 No.：AN015 Level：Public X1/T1/A1/C1 Version：2020.10 CONFIGURATION MANUAL INTRODUCTION This document briefly describes the default configuration of X1/T1/A1/C1, and guide the users to configure and use the products. www.bynav.com...
-
Page 2: Table Of Contents
X1/T1/A1/C1 configuration CONTENT 1 DEFAULT CONFIGURATION ....................1 ....................1 DEFAULT SERIAL PORT FORMAT ........................1 DEFAULT OUTPUT 2 BASE STATION CONFIGURATION ..................2 2.1 B ....................... 2 EFORE ONFIGURATION 2.2 C ......................2 ONFIGURATION TEPS 2.3 S ....................3... -
Page 3: Default Configuration
X1/T1/A1/C1 Configuration Manu 1 DEFAULT CONFIGURATION 1.1 Default Serial Port Format Table 1-1 Default Serial Port Format COM Ports Baudrate Input Output COM1 115200 BYNAV BYNAV COM2 115200 RTCM RTCM COM3 115200 BYNAV BYNAV ICOM1 115200 BYNAV BYNAV ICOM2 115200... -
Page 4: Base Station Configuration
X1/T1/A1/C1 Configuration Manu 2 BASE STATION CONFIGURATION 2.1 Before Configuration 1) Make sure the control ports is bynav format 2) After modification, make sure you have sent SAVECONFIG to save the configuration, otherwise the new configuration won’t be saved after reboot. -
Page 5: Set Base Station Position
\\ save configuration 3 ROVER STATION CONFIGURATION 3.1 Before Configuration 1) Make sure the control ports is bynav format 2) After modification, make sure you have sent SAVECONFIG to save the configuration, otherwise the new configuration won’t be saved after reboot. -
Page 6: Configuration Steps
\\ serial port, messages, frequency (red marked) adjustable 3.4 Serial Configuration Set serial port format INTERFACEMODE COM1 BYNAV BYNAV set com1 input and output in BYNAV format INTERFACEMODE COM2 RTCM BYNAV set com2 input RTCM and output BYNAV Set baudrate ... -
Page 7: Ethernet Configuration
X1/T1/A1/C1 Configuration Manu 4 ETHERNET CONFIGURATION The default IP address of X1/T1/A1/C1 is 192.168.8.151. You need to reset the IP address of the base or rover receiver in order to access to the local network, the steps are as below: 1）... -
Page 8: Udp Configuration
Set the static IP address of the receiver. Default IP 192.168.8.151, subnet mask 255.255.0.0, gateway 192.168.8.1. Set serial port format INTERFACEMODE ICOM2 RTCM RTCM \\ set com2 input and output in BYNAV format Set serial port network mode ICOMCONFIG ICOM2 UDP :2222 \\ set icom2 in UDP mode TEL：+86-731-85058117... - Page 9 X1/T1/A1/C1 Configuration Manu 图 4-3 Ethernet configuration in TCP mode TEL：+86-731-85058117 www.bynav.com...
Need help?
Do you have a question about the T1 and is the answer not in the manual?
Questions and answers