Installation - VINCENT SA-31MK Instructions For Use Manual

BUTTONS OF THE REMOTE CONTROL
16
17
18
26 Vincent
16. MUTE
Pressing this button once cuts the signals at the out-
puts "OUTPUT" (13) and "REC OUTPUT" (12) so
that the system's loudspeakers are muted. Pressing
it again returns to the original volume.
17. Input selector buttons
Select the input source you want to listen to with
these buttons.
18. VOLUME und VOLUME
These buttons change the amplifier's volume level
for the preamplifier outputs "OUTPUT" (13).

INSTALLATION

Set up the cable links in a sequence as follows. Connect the power cable between device
and power supply only after all other connections have been made.
DURING INSTALLATION PLEASE OBSERVE
THE FOLLOWING ADVICE:
Protective caps
Prior to the first installation the protective plastic
caps must be removed from all the connections
used at the rear of the unit.
1
OUTP UT
RCA connections
Mechanically identical RCA plugs are available for
analogue and digital outputs. Make sure that you
do not get these connections confused during
installation!
Make sure that you do not mix up the analogue con-
nectors for right and left. The RCA plugs for these are
mostly colour coded as follows: red for the right
channel, black or white for the left channel.
Contacting the middle pin of the RCA plugs with the
outer ring of the RCA chassis jack may lead to dama-
ges to the main amplifier if it is switched on! To avoid
this hazard, connect or disconnect only in switched-
off state and more than one minute after deactivating!
CONNECTION OF THE POWER CABLE
Check whether the wall socket provides the appropriate mains power, which is the case if it is supplied with
230 V AC 50 Hz. Push the plug on the power cable supplied firmly into the power socket on the back of the
appliance. Plug the other end of the power cable into a mains socket.
Cable connections
Make sure that all plugs fit tightly. Inadequate con-
nections can cause noise interference, failures and
malfunctions.
2
OU
- wrong - - correct -
To make the most of the components' sound poten-
tial, only high quality loudspeakers and connecting
cables, for example Vincent cables, should be
used. Your local stockist will be glad to advise you
about this.
Vincent 27