Am/Fm.tuner - Coby DVD-937 Instruction Manual

Your player comes with a built-in AM/FM tuner. To use the AM/FM tuner:
1. Make sure that the AM loop antenna and the FM antenna have been connected properly on
the rear panel of the player.
2. Press MODE to enter AM/FM mode.
3. Press the AM or FM button to listen to the AM of FM band, respectively.
4. Press STOP to toggle between the two tuning modes: CH (preset) and Tune (manual).
• CH Mode: Listen to Preset Channels.
This is the default tuning mode. Press the TUNING + / - buttons to tune to higher or
lower preset channels, or press the CHANNEL + / - keys on the remote.
• Tune Mode: Listen to Manually-Tuned Channels.
The front-panel display will read "Set Tune" when the radio is in Tune Mode. Press
the TUNING + / - buttons to tune to higher or lower station frequencies, or press the
CHANNEL + / - keys on the remote. Press and hold TUNING + / - to auto-seek to the
next station in reception range.
Note: If a button or key has not been pressed for longer than approximately 3 seconds in Tune
Mode, the player will automatically switch back to the default CH Mode.
• To store preset channels automatically:
• Press AUTO. The player will automatically scan the entire band and memorize any
stations in reception range. This will overwrite any previously store channels. To stop
Auto-Search, press STOP again.
• To store preset channels manually:
1. Press MEMO to manually store the current station as a preset channel. The front-
panel display will flash "F 00"
2. Use the numeric keypad to enter the desired preset channel number.
3. Press MEMO again to store the preset channel.
• To delete a preset channel:
• Tune to the preset channel you want to delete, and then press CLEAR to delete it.
22
AM/FM TUNER