Installing The Raid Drivers - TYAN TOMCAT K8E Manual

Installing the RAID Drivers

1. After you complete the RAID BIOS setup, boot from the Windows CD. The
Windows Setup program starts.
2. Press F6 and wait a few moments for the Windows Setup screen to appear.
Windows Setup
Setup could not determine the type of one or more mass storage devices installed in
your system, or you have chosen to manually specify an adapter. Currently, Setup
will load support for the following mass storage device(s):
<none>
*To specify additional SCSI adapters, CD-ROM drives, or special disk controllers for
use with Windows, including those for which you have a device support disk from a
mass storage device manufacture, press S.
*If you do not have any device support disks from a mass storage device
manufacturer, or do not want to specify additional mass storage devices for use with
Windows, press ENTER.
S=Specify Additional Devices
3. Specify the NVIDIA drivers.
a. Insert the floppy that has the RAID driver, press S, then press Enter.
The following Windows Setup screen appears:
Windows Setup
You have chosen to configure a SCSI Adapter for use with Windows, using a
device support disk provided by an adapter manufacturer.
Select the SCSI Adapter you want from the following list, or press ESC to return to
the previous screen.
NVIDIA RAID CLASS DRIVER (required)
NVIDIA NForce Storage Controller (required)
Enter=Select
ENTER=Continue
F3=Exit
78
http://www.tyan.com
F3=Exit