Installing The Memory - TYAN TOMCAT K8E Manual

2.10 - Installing the Memory

Before attempting to install any memory, make sure that the memory you
have is compatible with the motherboard as well as the processor.
The following diagram shows common types of DDR SDRAM modules:
•Always install memory beginning with DIMM1
•128MB, 256MB, 512MB, 1GB, and
Reg/Non-ECC PC3200/PC2700/PC2100 DDR SDRAM memory
modules are supported.
•All installed memory will be automatically detected and no jumpers or
settings need to be set.
•The Tomcat K8E supports up to 4GB of memory.
•Registered Memory is not supported.
* Not validated at the time of print and subject to
DIMM Slot
64 bits
support
128 bits
support
NOTE:
Symmetrical DIMMS must be identical
- Same DRAM technology, eg 128-bit, 256-bit, etc
- Same DRAM bus width, eg x8 or x16
- Matched Sided DIMMs (single-sided or double-sided)
Memory Population Rule
(Note: X indicates a populated DIMM Slot)
DIMM1
X
X
X
X
http://www.TYAN.com
DDR Unbuffered
DDR Unbuffered ECC
2GB* Non-Reg/ECC or Non-
change.
DIMM2 DIMM3
X
X
28
DIMM4
X
X
X X
X X