Save To Cmos And (Y/N) - TYAN TOMCAT I845GV Manual

password. Type the password again and press <Enter>. You may also press <Esc> to abort the
selection and not enter a password.
To disable a password, just press <Enter> when you are prompted to enter the password. A
message will confirm the password will be disabled. Once the password is disabled, the system
will boot and you can enter Setup freely.
PASSWORD DISABLED.
When a password has been enabled, you will be prompted to enter it every time you try to enter
Setup. This prevents an unauthorized person from changing any part of your system
configuration.
Additionally, when a password is enabled, you can also require the BIOS to request a password
every time your system is rebooted. This would prevent unauthorized use of your computer.
You determine when the password is required within the BIOS Features Setup Menu and its
Security option (see Section 3). If the Security option is set to "System", the password will be
required both at boot and at entry to Setup. If set to "Setup", prompting only occurs when trying to
enter Setup.
3.14-Save to CMOS and EXIT (Y/N)?
Pressing <Enter> on this item asks for confirmation
Pressing "Y" stores the selections made in the menus in CMOS – a special section of memory that
stays on after you turn your system off. The next time you boot your computer, the BIOS
configures your system according to the Setup selections stored in CMOS. After saving the values
the system is restarted again.
37
http://www.TYAN.com