Power Management Setup - TYAN TOMCAT I845GV Manual

Onboard FDC Controller
Onboard Serial Port 1
Onboard Serial Port 2
UART Mode Select
UR2 Duplex Mode
Onboard Parallel Port
Parallel Port Mode
ECP Mode Use DMA
3.6 – Power Management Setup
Options related to power management can be altered through the following:
Enabled
Disabled
Disable,
3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4,
2E8/IRQ3,
Auto
Disable,
3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4,
2E8/IRQ3,
Auto
Normal
IrDA
Askir
SCR
Half
Full
Disable
378/IRQ7
278/IRQ5
3BC/IRQ7
SPP, EPP, ECP, ECP+EPP
1
3
29
http://www.TYAN.com
Leave this setting as it is.
Sets the address for the
onboard Serial Port .
Refer to this Manual
Chapter 2.09- LCD
CONNECTER (J20),
J20 pin header
Set the UART Mode
Set the UR2 Duplex Mode
Sets the address of the
onboard parallel port.
Sets the operation mode
of the parallel port.
Configures the parallel
port DMA channel for the
selected ECP mode.