Volvo S80 - 2003 Manual page 96

2003 Volvo S80
HomeLink® Universal Transceiver (option)
pg. 151 HomeLink® Universal Transceiver (option)
HomeLink® Universal Transceiver
HomeLink® is an advanced system that can be programmed to learn the codes of three different
remote controlled-devices (e.g., garage door openers, remote lighting, entry door lock).
HomeLink®'s sun visor-mounted transceiver, powered by your car's electrical system, may then be
used in place of your hand-held remote controls.
NOTE: As a security precaution, the HomeLink® Universal Transceiver is designed to not function
if the car has been locked from the outside.
Programming the transceiver
1. The ignition switch must be turned to the "accessory" position (II) before programming the
HomeLink® Universal Transceiver.
2. Begin by erasing all 3 factory default channels. Hold down the two outside buttons (buttons 1 and
3 in the illustration) on the HomeLink® Universal Transceiver for about 20 seconds, until
HomeLink®'s indicator light begins to flash. Then release the buttons.
3. Hold your hand-held transmitter (garage door opener, for example) 2 to 5 in. (5 to 12 cm) away
from the HomeLink® surface, keeping the indicator light in view. For placement questions, contact
HomeLink® toll-free 1-800-355-3515 (Internet: www.HomeLink.com).
4. Using two hands, push and hold both your hand-held transmitter's button and the transceiver
button you wish to program. The indicator light will flash first slowly, then rapidly. Rapid flashing
tells you the HomeLink® button has been successfully programmed. Release both buttons.
5. If you are programming a rolling code-equipped device (e.g., garage door opener or entry door
lock), refer to "Programming rolling codes" on the next page to complete the programming process.
Repeat steps 3 and 4 to program the other two transceiver buttons.
http://apps.volvocars.us/ownersdocs/2003/2003_S80/03s80_11.htm
2 0 0 3
VOLVO
S80
Page 1 of 4
8/10/2005