Volvo S80 - 2003 Manual page 67

2003 Volvo S80
Position the jack on the bar in the attachment (A in the illustration below) and crank while
simultaneously guiding the base of the jack to the ground. The base of the jack must be flat on a
level, firm, non-slippery surface. Before raising the car, check that the jack is still correctly
positioned in the attachment.
Raise the vehicle until the wheel to be changed is lifted off the ground.
Unscrew the wheel bolts completely and carefully remove the wheel so as not to damage the
thread on the studs.
NOTE: To avoid excessive wear and the necessity of rebalancing, mark and reinstall wheels in the
same location and position as before removal. To lessen the chance of imbalance, each wheel hub is
equipped with a guide stud to ensure that a removed wheel can be reinstalled in its original position
(as when changing over to winter tires/wheels).
pg. 97 Changing wheels
Installing the wheel
http://apps.volvocars.us/ownersdocs/2003/2003_S80/03s80_07.htm
Loosen wheel bolts
Attaching the jack
Correct tightening order for wheel bolts
Page 6 of 7
8/10/2005