Pioneer DJM 3000 - Professional DJ Mixer Operating Instructions Manual page 7

2. Connection of Outputs, Microphones, etc.
Microphone 1
External effector
SEND
R L
(MONO)
R L R
1 2
SEND
DIGITAL OUT
CD recorder, etc. Cassette deck, etc.
*6 MASTER LEVEL ATT.
(Master output-level attenuator shaft)
This shaft is used to decrease the output level to protect
connected amplifiers and speakers from excessive input.
(Attenuation: – to 0 dB)
*7 Connect if you want to use another device for adjusting
sound quality.
SEND (output):
Connect this to the external effector's input terminal.
When using a monaural input effector, connect it to the L
channel output. The effector will receive LR-mixed sound.
RETURN (input):
Connect this to the external effector's output terminal.
When using a monaural output effector, connect it to the
L channel output. The signals from the effector will be
input to both the L and R channels.
DJM-3000
Power amplifier
(Supports XLR input)
R
3 COLD
1 GND
2 HOT
RETURN MASTER
MASTER OUT 2
R L OUT 1 MONITOR
(MONO)
L
R L R L
RETURN MASTER
REC OUT
MASTER OUT 2
OUT 1 MONITOR
R L
XLR terminal polarity is as
shown in the diagram below.
2
Power amplifier Power amplifier
(Supports RCA input) (For booth monitor)
L L R
CH - 4 CH - 3
BOOTH
PHONO 3
PHONO 4 LINE 7 / LINE 6
L L
PHONO LINE
TALK OVER
LEVEL
R MASTER R
LEVEL
BOOTH PHONO 4 LINE 7 CONTROL PHONO 3
ATT. / LINE 6
CH - 4
HOT (+)
3
COLD (–)
1 GND
*8 REC OUT
Outputs sound to the same output source as the master
output, without being influenced by the master volume,
master balance and MONO/STEREO switches.
*9 TALK OVER LEVEL attenuation control
Attenuates sound level from sources other than MIC 1
and 2 when the MIC switch is set to the TALK OVER
position (range: –4 to –20 dB).
*10 MIC 1
Supports microphones with either XLR or PHONE type
jacks.
*11 DIGITAL OUT
Outputs same source as the master output.
The output level is not affected by MASTER LEVEL ATT.
(*6).
DJM-3000
CH - 2 CH - 1
PHONO 2
PHONO 1
LINE 5 / LINE 4 LINE 3 / LINE 2
L L
PHONO LINE
PHONO LINE
SIGNAL
R R
GND
LINE 5 CONTROL PHONO 2 LINE 3 CONTROL PHONO 1
/ LINE 4 / LINE 2
CH - 3 CH - 2
MIC 3
(CH-4 PHONO 4 cannot
be used when
microphone is connected
to MIC 3.)
CONNECTIONS
Headphones
Microphone 2
LINE 1
L
R
LINE 1 CONTROL
CH - 1 CH-4 MIC 3 MIC 2
7
<DRB1314>